Informações gerais
About Biomass boilers
Biofuels offer challenges in order to reach high efficiency and availability. Biofuel normally tends to create gas-side fouling in all parts of the boiler.
Sobre limpeza
Benefits of our soot cleaning systems for Biomass boilers
Reduced steam consumption for steam sootblowing. Saved sootblower steam is used for increasing heat or electricity production.
Lower fuel consumption. Cleaner tubes mean increased heat transfer and efficiency.
Pressão diferencial mais baixa e mais estável. Infrasound cleaning reaches areas that are not accessible to conventional soot cleaning systems. This means higher availability of the boiler and lower load on ID/FD fans.
Fewer and shorter outages for manual cleaning. With improved cleaning effect you can obtain higher availability and fewer man-hours spent.
Maior vida útil dos trocadores de calor. By reducing or eliminating steam sootblowing or shot cleaning, the lifetime of heat exchangers is prolonged. Infrasound cleaning is a non-abrasive cleaning method that does not wear on heat exchange surfaces or catalyst elements and does not contribute to corrosion or erosion. Using our optimized steam sootblowing also reduces wear since steam is supplied only half the time.
References on Biomass boilers
Finspångs tekniska verk, Finspång Sweden
A case study and results of an infrasound installation at Finspångs tekniska verk. Before installing the infrasound generator at Finspångs tekniska verk, there were two audible sonic horns installed on the smoke tube boiler.
Sandviken Energi, Storvik Sweden
At Sandviken Energi, The smoke tube boiler produces the basis of Storvik’s district heating. There was previously no soot cleaning equipment installed on the boiler.
Moelven Sawmill, Edane Sweden
A case study and results from our infrasound cleaning installation on a Biomass boiler at Moelven Sawmill. At Moelven Sawmill a Compressed air sootblowing is installed but is relatively weak due to nozzles being installed on the turning chamber between the two tube passes, far from the inlet of the first tube pass where most of the deposits are found.
Skogsbacka Kraftvärmeverk, Lycksele Sweden
Skogsbacka Kraftvärmeverk was using steam soot blowing in the economizer once every 24 hours prior to the installation of the infrasound generator. The performance of the existing soot blowers was not satisfying and the cost for maintenance of the soot blowing system was considered too high
Articles related to Biomass boiler
O otimização do desempenho do caldeirão para os gerentes de fábricas: melhores práticas e estudos de caso
Every shift, the pressure is on. You’re balancing production targets, managing operational budgets, and fighting for every minute of uptime. [...]
Optimizing Energy Efficiency in Biomass Plants: A Technician’s Guide to Boiler Cleaning Innovations
The Limitations of Conventional Cleaning: Why Traditional Methods Fall Short For decades, the primary weapon in this fight has been [...]
Além da detecção: usando sistemas preditivos para mitigar os riscos de transferência térmica no caldeirão
It’s 3 AM. The control room is quiet, bathed in the steady glow of monitors. Suddenly, an alarm shatters the [...]
